To run the soak test on the Magicard Enduro 3E follow thees steps.
The Maintenance Mode allows the User to check the functionality of the printer. Make sure 1 card is in the hopper at the back before starting the process.
1. Open lid and remove ribbon
2. Hold down the Next / Menu Button for 5 seconds.
3. Hit Menu button (when maintenance is showing)
4. When Soak test is displayed, hit OK button.
5. Close Lid
6. The card will be fed from the back and the soak test will start.
Leave the soak test to run for 10 minutes then click cancel.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article