Magicard Prima 4 + 8 Retransfer adjustment for patches in print

Modified on Wed, 7 Dec, 2022 at 2:53 PM

If you have white patch areas on a printed card on the Prima 4 + 8 you may need to increase your retransfer settings. 


This can be done via the settings in the “CX-D80 status monitor“ Program which should be installed on your PC along with the printer driver.



Search for "CX-D80 Status Monitor" and run as administrator for full control. of the program.



If you refer to page 111 in the attached manual explains how to set the setting(as above) . 


increase the temp or slow down the speed of re-transfer to get a better result on the cards you are using.

 

Not all plastic cards are made equal and these settings are available to compensate for these differences.


Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article