The SMART-50 Laminator check list for correct fconfiguration
1. Heater Temperature (Old head: 150'c, New head: 160'c)
2. Laminating with pulse (8000 default.. or more)
3. Lami start card Pos. (5 default.. adjust it)
If the attached position is not abnormal, please check no.3.
If it still occurs, check the card is slipped.
1. Clean the rollers
2. Idle tension roller is old or not. The new one has a groove in the center. (See the attached picture.)
3. Flim In/Out sensor : If it is out of order, it occurs
4. Lami. Ribbon motor: if it is weak, it occurs
Please check one by one.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article