Increasing/Decreasing the YMC as well as the K power settings with your Evolis Primacy printer is an important step for resolving ribbon snapping issues.
Increase/Decrease Printhead Power
- and doubleOpen the Evolis Print Centre, Double-click on the Primacy printer.
- Click on the Printing Tab.
- Click on Front Side Graphical Settings.
- Use the slider bar to increase/decrease the Brightness and/or Contrast Heat (green box) as well as the Monochrome Resin Heat (red box). You may need to experiment a bit by printing a couple of cards to test the optimal values for these settings.
Try to change the settings in incremental/decremental step of 2 each time, and then perform a test print each time after the change. As each printer’s hardware is not the same, you may need to perform a couple or more adjustments/test prints before locating the optimal settings that make the ribbon more stable.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article